What Goes Under Before Installing Wall To Wall Carpet

Use a power stretcher to firmly stretch and secure the carpet onto the tackless strip on each side of the room.

What goes under before installing wall to wall carpet. No baseboards do not need to be removed. The carpet installer can run the tack strip up to the trim then roll excess carpet under the trim. Once one corner is hooked with the knee kicker use the power stretcher to stretch the carpet to the opposite wall. The baseboard at the bottom of a wall should always be installed slightly raised from the floor s surface.

There are two reasons for this gap which is generally required by building codes. Reach in front of the power stretcher to hook the carpet onto the tack strip. When installing baseboards before carpet ask the installer how large of a gap to leave between the floor and the trim e g. The tacks on the strips are sharp and could poke through the carpet and hurt your feet.

Put the base of the power stretcher at the wall that was just hooked with the knee kicker. Continue along the wall then trim excess with the wall trimmer and tuck the edge underneath the baseboard. Push the lever down to stretch the carpet taut. For most installers this is not a problem and can be done easily.

Nail the strips 1 2 from the wall image 2. Most popular room with cotton backing made from seeping through to wall to wall carpet into 4footwide strips in each strip place all of carpeting sometimes shell choose as in a different subcategories of your walltowall carpet onto the western united states.